Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!

raspberry Tinkercad Case

by Cinezaster, published

raspberry Tinkercad Case by Cinezaster Sep 20, 2012

Thing Info

25870Views 3938Downloads Found in DIY
Report Thing


Raspberry Pi case based on the tinkercad raspberry Case
This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/1G95U34sXt9


It's a clean fit, only I would prefer that the raspberry would fit more snug.
Also going to make a ridge on the bottom part so the to would click into place.

More from DIY

view more

Thing Info

25870Views 3938Downloads Found in DIY
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

why is one piece elevated?

See my remix.

why is one piece higher than the other in the stl? I'm not able to print this at all. It needs a revision. or seperate stl files... trying to correct this in solidedge

CaptKirk - in reply to

See my remix.

Timelaps of my print on the Ultimaker: http://www.youtube.com/watch?v=B45AFbTpF_4http://www.youtube.com/watch?v...

I used support materials, the first print without was very saggy

would you suggest using support material, or is it unneccesary?

i did not use any support material.

I put this on a raft and I agree that it was probably unnecessary. The large surface area made it difficult to remove all of the support material.

Next time I will do it without a raft.