Maker Gear direct drive extruder mount
3
Likes
113
Downloads
1465
Views
Published on September 20, 2012
Description
I broke my MG prusa direct drive extruder mount so i printed out a new one on my backup printer. All stock parts fit.
Instructions
Print and enjoy. No drilling or anything needed, however i made the hole fot the filament 2mm so you will need to ream it out if you are using 3mm filament.
You must be logged in to post a comment.
License
Maker Gear direct drive extruder mount by gitrdun is licensed under the Attribution - Share Alike - Creative Commons license.
More from gitrdun
More from 3D Printer Extruders
Would you mind uploading your original files so we can hack at this?
All of makergears models are available here on github.
https://github.com/MakerGear/M...
Though you might as well print this one out next time, it'll give you 2cm greater x distance. http://www.thingiverse.com/thi...