OpenSCAD Y Bracket
10
Likes
408
Downloads
1352
Views
Published on September 21, 2012
Description
Prusa's original DXF for his Y motor bracket made the curves too chunky for my liking, so I remade it in OpenSCAD. Now I can take full advantage of my firmware's jerk setting and get beautifully smooth curves at full speed.
I also added slots so that it's easier to install, or switch for my thingiverse.com/thing:15988 . They're oriented so that as much structural stiffness as possible is retained.
I also added slots so that it's easier to install, or switch for my thingiverse.com/thing:15988 . They're oriented so that as much structural stiffness as possible is retained.
Instructions
1) Print
2) Observe smooth curves instead of faceted, lumpy ones
3) Use
2) Observe smooth curves instead of faceted, lumpy ones
3) Use
More from triffid_hunter
More from 3D Printer Parts
You must be logged in to post a comment.