MakerBeam slider
5
Likes
117
Downloads
644
Views
Published on September 21, 2012
Description
This piece can be attached to a makerbeam, so another makerbeam can slides through it by a 90° angle.
This works quite nice at low speeds. I even use it on my printer!
This works quite nice at low speeds. I even use it on my printer!
Instructions
1. Download file
2. Print out (maker sure infill is 100%)
3. Mount on MakerBeam using two M3 bolts and nuts
2. Print out (maker sure infill is 100%)
3. Mount on MakerBeam using two M3 bolts and nuts
License
MakerBeam slider by Tectu is licensed under the Attribution - Share Alike - Creative Commons license.
More from Tectu
More from 3D Printer Accessories
You must be logged in to post a comment.