Razer Blade Holder & Scraper
17
Likes
582
Downloads
590
Views
Published on May 10, 2010
Description
There was a single edge razor blade included with my makerbot to use for removing parts from the build platform. I do not like using a naked blade, and did not have a holder for it, so I made one.
Instructions
First ensure that the top and bottom parts fit snugly together. I made them with a very tight fit, so you may need to file them a small amount to get things together. This is on purpose, to ensure nothing falls out of place.
Fit the blade into the bottom part, then clip the top part over the blade.
Fit the blade into the bottom part, then clip the top part over the blade.
You must be logged in to post a comment.
MaskedRetriever
on
May 10, 2010
said:
Seems like this wouldn't be too hard to extend to an actual face-shaving razer, although I'm probably not giving up my multiblade cartridge model any time soon...
Anonymous
on
May 11, 2010
said:
Hmm... That is actually a pretty good idea.. I wonder if I could get the accuracy good enough to print a multi blade razor that works almost as good as the store bought ones.
Something like this, but with small spacers between the blades (I'm thinking one layer), with less blade exposed, and at an angle could work. I might look into this when i manage to find a box of razor blades.
License
Razer Blade Holder & Scraper by suavepotato is licensed under the Attribution - Share Alike - Creative Commons license.
I tried making one of these, but it does not fit the razors I have. The recess is not long enough for the back end of the razor to fit in there, with the holes in that position. It seems there's quite a bit of variance in dimensions between different razor blade manufacturers.