Replicator1 - 3 x Corners
4
Likes
144
Downloads
760
Views
Published on October 5, 2012
Derived from
Replicator Corner Hole Plug
by DDStarkey
Description
This derivative is the same as the original - just three corners into one file to print them in one go.
Instructions
For details details, refer to the original Thing by DDStarkey.
I've published both the Sketchup design file and resulting STL export.
Note 1: The Sketchup STL export seems to cause error messages in ReplicatorG when generating gCode, however it works fine when I printed it.
Note 2: My Replicator has several adhesive tabs keeping the cables in place - bear in mind the height of these plugs may mean you need to move the lowest tab up a bit so they go in okay.
I've published both the Sketchup design file and resulting STL export.
Note 1: The Sketchup STL export seems to cause error messages in ReplicatorG when generating gCode, however it works fine when I printed it.
Note 2: My Replicator has several adhesive tabs keeping the cables in place - bear in mind the height of these plugs may mean you need to move the lowest tab up a bit so they go in okay.
License
Replicator1 - 3 x Corners by gth is licensed under the Attribution - Share Alike - Creative Commons license.
More from gth
More from 3D Printer Accessories
You must be logged in to post a comment.