Micro USB carkit holder
by Cyrus3D, published
I wanted a charger with my carkit holder, but these are not most of the time not universal and quite expensive when you buy it for your phone model. ( I got the SIII and it was like 55,- Euro)
So I got myself a cheap carkit, and printed out a micro usb holder so I can click in the phone everytime I get in the car so I don't have to look for the cable to plug it in first, then put it in my carkit.
- Print it
- apply little bit of glue
- charge :)
p.s. I could have made holes for holding the parts instead of glue, but there is not much room, I would have to make the part larger etc.. 9
I've used it for an Galaxy S2 and S3, but I don't see a problem using other phones since the usb slot is centered
Liked ByView All
Give a Shout Out
Micro USB carkit holder by Cyrus3D is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving Cyrus3D a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Cyrus3D would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).