iPhone 5 stand
by tkramm, published
Maybe I'll add a option to put a Lightning Cable in later.
Recent Commentsview all
It fits perfect, almost a little bit too tight. I needed to hold the stand with my hand to remove my iPhone 5. I printed it several times on an Ultimaker 1 with PLA from Colorfabb and 0.2 layers. After scaling the model in my slicer very slightly to 1.02 of the original size, it now fits even better. And I can remove the iPhone 5 from the stand without holding it by hand.
I uploaded the SCAD file. But you will also need the Mockup STL:Â http://www.thingiverse.com/thi...
Liked Byview all
Give a Shout Out
2. Put the iPhone 5 in
I printed it with 0.25mm layer height, .5mm nozzle, 2 perimeters and 40% Infill....
You must be logged in to post a comment.