Proud Rooster Sliced to Print
31
Likes
657
Downloads
7663
Views
Published on September 22, 2012
This thing was Featured on September 22, 2012
Derived from
Proud Rooster
by M1ch13l
Description
My Daughter wanted to print this rooster but I didn't want to use support so I sliced him in half. Hopefully your bridging is working well for the legs.
Instructions
Print without support and glue both halves together and have a clucking good time.
License
Proud Rooster Sliced to Print by MacGyver is licensed under the Attribution - Creative Commons license.
Hi MacGyver,
How nice to see Proud Rooster come "alive". Can you tell a little about your working process? You sliced the STL (what program did you use), you 3D printed both halfs (what printer and what material), and you then casted it to make moulds?
Cheers,
Michiel