PrintrBot Plus simple filament guide
8
Likes
303
Downloads
1632
Views
Published on September 23, 2012
Description
this is a simple filament guide for the printrbot plus that sits on one of the smooth rods.
Instructions
if you can be there when it is done printing I found it works best to put it on one of the posts to cool this results in a nice snug fit.
using the basic setup settings from the Printrbot setup guide worked well
using the basic setup settings from the Printrbot setup guide worked well
License
PrintrBot Plus simple filament guide by Aecium is licensed under the Attribution - Share Alike - Creative Commons license.
More from Aecium
More from 3D Printer Accessories
You must be logged in to post a comment.