High Heeled Shoe
by MakerBot, published
Check out these awesome shoes! The straps are printed fully connected and clip into place into the side of the shoe. The shoe was printed in pieces, but if printed upright and assembled it does fit in the build volume of the MakerBot ReplicatorÃÂ¢Ã¢ÂÂÃÂ¢2 Desktop 3D Printer. I'd advise against wearing these though. Though these are very sturdy, they were created just as a proof of concept and as display pieces.
These look great with the matching MakerBelt!
Created by Todd
Print out all the pieces. Use the clips on the bottom of the shoe to hold them together, and then insert the print-in-place straps into the clip holes on the side. The heel of the shoe was glued in place with E-6000 contact cement. The 16 link long strap goes in the top two holes, and the 10 link long strap goes in the bottom two holes. They were printed with 30% infill and 2 shells.
Liked ByView All
Give a Shout Out
High Heeled Shoe by MakerBot is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving MakerBot a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure MakerBot would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).