Safe with cardinal direction
16
Likes
110
Downloads
1459
Views
Published on September 27, 2012
Description
Here another safe for some stuff like "geocache" or anything else.
To unlock the safe turn the "cardinal direction" in the right position.
To unlock the safe turn the "cardinal direction" in the right position.
Instructions
-Print it with a 3D Printer and PLA.
-Infill 20%
-With support material
-Printtime ~20h
-Volume ~100mm x 100mm outside
-Sanding with a little dremel
-drill a 1.5mm hole in the groove
-Sprayed with black paint
-put some heavy wire in the hole,bend it that the knobs don´t fall out
have fun!
-Infill 20%
-With support material
-Printtime ~20h
-Volume ~100mm x 100mm outside
-Sanding with a little dremel
-drill a 1.5mm hole in the groove
-Sprayed with black paint
-put some heavy wire in the hole,bend it that the knobs don´t fall out
have fun!
You must be logged in to post a comment.
License
Safe with cardinal direction by Nr5Alive is licensed under the Attribution - Non-Commercial - Share Alike license.
Interesting idea!
Hmm, if the lid was attached to a ring that slipped over the middle of each dial, then the dials would be held captive until the box was opened.