Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
MangoPower v0.2
2
Likes
55
Downloads
722
Views
Published on September 28, 2012
Description
Alison needed a board to control some lights, flipping them on and off at timed intervals. I built this atmega168 based relay board to do just that. Running on a regulated 5v power supply the board can control up to 5 relays.
The software was written in the arduino ide, but the chips were not burned with the arduino bootloader. Instead, the sketch was burned straight to the chip to allow for no delay on power up.
(v0.1 had the barrel jack wired backwards. How embarrassing.)
The software was written in the arduino ide, but the chips were not burned with the arduino bootloader. Instead, the sketch was burned straight to the chip to allow for no delay on power up.
(v0.1 had the barrel jack wired backwards. How embarrassing.)
Instructions
No instructions provided.
License
MangoPower v0.2 by asp55 is licensed under the Attribution - Share Alike - Creative Commons license.
More from asp55
More from Electronics
You must be logged in to post a comment.