Massage Rollers
12
Likes
142
Downloads
757
Views
Published on September 29, 2012
Description
Got tired feet? You'll love this!
After trying to roll around a foot massager on the floor, I felt compelled to design my own that doesn't walk around on the carpet.
Enjoy!
After trying to roll around a foot massager on the floor, I felt compelled to design my own that doesn't walk around on the carpet.
Enjoy!
Instructions
This is an 8 roll device. It can be expanded on but you'll need to create a bigger housing.
The rollers were printed in halves and glued together with the help of a 1/4" bolt.
Once the glue is setup the rollers can then be stacked together on an all-thread rod that runs through the housing.
2 flat washers were used on the two inside extreme ends for a tight fit.
..and yes it works well!!
enjoy!
The rollers were printed in halves and glued together with the help of a 1/4" bolt.
Once the glue is setup the rollers can then be stacked together on an all-thread rod that runs through the housing.
2 flat washers were used on the two inside extreme ends for a tight fit.
..and yes it works well!!
enjoy!
You must be logged in to post a comment.
License
More from XSF1
More from 3D Printing
Hmm, I'd think the rollers could be printed in whole pieces as long as the spikes remain shallower than 45 degrees.