bearing holder
5
Likes
221
Downloads
877
Views
Published on October 3, 2012
Description
a bearing holder for the timing belt
removing the need for an extra bearing for belt drift
removing the need for an extra bearing for belt drift
Instructions
no need for the large washers just print the two parts insert your bearing and your done, it clips ogether perfect you can if wanted add a touch of super glue, this is to replace the need for two bearings so the bely has room to drift
You must be logged in to post a comment.
License
bearing holder by wardenet is licensed under the Attribution - Share Alike - Creative Commons license.
More from wardenet
More from 3D Printer Parts
Looks the same as Greg's bearing guide, http://www.thingiverse.com/thi..., that my thing, http://www.thingiverse.com/thi..., was based on.