Extruder Temperature Control Housing for UP!
by art103, published
The UP! does not allow software control of the extrusion temperature, so I developed a board that can be connected between the extruder and the main board to allow control of the temperature.
Recent Commentsview all
Electronically, the 16-pin version should be compatible with the Up Mini.
The issue is that the cables must be routed out of the heated enclosure as the temperatures may exceed the maximum ratings of components on the board.
Details can be found here (including a link to my store):
For 5+ units, the coupon code "10MULTI5" will get a 10% discount.
I posted the key details on how to manipulate the temperature on the pp3dp forums; however I'm afraid the board and firmware for this particular product are not open source.
Liked Byview all
Give a Shout Out
I used the minimum support setting and 0.25mm layers on the UP! printer.
I also used the wind barrier to blow air across the build.
More details here:
You must be logged in to post a comment.