Double filament guide for Replicator
4
Likes
200
Downloads
763
Views
Published on October 3, 2012
Description
This fits on the side of the Replicator using two of the case screws to hold it in. I sit the reels on these - thingiverse.com/thing:23034 and they work really well.
Instructions
Print using a raft and support as the underneath has a cutout to clip it to the frame of the Replicator.
A couple of 623 bearings (3x10x4)help the filament through, held in place by small screws.
A couple of 623 bearings (3x10x4)help the filament through, held in place by small screws.
License
Double filament guide for Replicator by pintokitkat is licensed under the Attribution - Share Alike - Creative Commons license.
More from pintokitkat
More from 3D Printer Accessories
You must be logged in to post a comment.