Makerbot filament reel winder hub
3
Likes
183
Downloads
539
Views
Published on October 3, 2012
Description
This squashes into the side of one of Makerbot's filament reels so you can attach a power drill to re-wind filament perhaps from reels that don't fit on the back of the machine properly.
Instructions
Print it with a 30% fill to keep it reasonably strong and fit a 8mm bolt through the hole. Lock the bolt on with a Nyloc nut to stop it unscrewing in use (or use two nuts).
Remember to spin the drill slowly - you wouldn't want the reel to fly off and decapitate the cat, now would you?
Remember to spin the drill slowly - you wouldn't want the reel to fly off and decapitate the cat, now would you?
License
Makerbot filament reel winder hub by pintokitkat is licensed under the Attribution - Share Alike - Creative Commons license.
More from pintokitkat
More from 3D Printer Accessories
You must be logged in to post a comment.