Adjustable Tablet Stand
by countspatula, published
I liked ljon's stand but it was a bit unstable and had some geometry problems, so I added a support to the back and did some clean up.
This has been working great for our Nook and Kindle.
I really wanted to print all the parts but due to time I stuck with the hardware and it works well.
You will need:
M4, #6 or #8 rod about 58mm or 2.25" long x2
M4 or #8 screws at least 20mm or .75" long x2
10 matching nuts
Threadlocker (superglue will work)
You may need to file or drill out the holes slightly depending on your hardware.
Assemble as shown, the key is to threadlock all the nuts, otherwise it will fall apart. On the arm pivot, threadlock the nuts slightly loose so it can move freely.
Liked ByView All
Give a Shout Out
Adjustable Tablet Stand by countspatula is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving countspatula a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure countspatula would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).