Raspberry Pi VESA 200 mount
by mrath, published
A case and mount for the Raspberry Pi computer, that fits a VESA 200 mount.
Works with standing and wall-mounted TVs (but is not tested yet).
A large print, but should print on the Makerbot Replicator.
Recent Commentsview all
Ok, just tried to print this using the latest Makerbot Replicator. Tried it twice actually. Both times on the case stl file, the vesa arms printed fine, but no case in the middle, just two loose arms. Printed the washers fine too. Any suggestions?
Liked Byview all
Give a Shout Out
Print the case and lid, mount the case in any two adjacent VESA mounting holes using M6 bolts.
Print case, lid and 2 washers, mount case and washers between wall mount and TV.
(This is not tested, so use at your own risk! Better tighten the screws, even if you risk breaking the case - it is better than breaking your TV...)
You must be logged in to post a comment.