3D Printer Spool Holder
1
Likes
99
Downloads
1505
Views
Published on October 5, 2012
Description
A very functional, useful, cheap and customisable 3D printer spool holder!
Instructions
You print 4 of these.
You get 4 608ZZ bearings.
You get 4 larger style 8mm washers,i.e. 8mm I.D, >30mm O.D. is good.
You get 12 8mm nuts.
You get 8mm threaded rod to suit.
Put it all together! Note the spool holders have 2 flat sides and 2 stylised sides. Where nuts join USE the flat sides. Be gentle putting the rod in so as to not let the print crack.
Enjoy
You get 4 608ZZ bearings.
You get 4 larger style 8mm washers,i.e. 8mm I.D, >30mm O.D. is good.
You get 12 8mm nuts.
You get 8mm threaded rod to suit.
Put it all together! Note the spool holders have 2 flat sides and 2 stylised sides. Where nuts join USE the flat sides. Be gentle putting the rod in so as to not let the print crack.
Enjoy
You must be logged in to post a comment.
License
3D Printer Spool Holder by suiiiiie is licensed under the Attribution - Share Alike - Creative Commons license.
More from suiiiiie
More from 3D Printer Accessories
Could I see a photo of an assembled one?
Voila! :)