Pumpkin
8
Likes
230
Downloads
1143
Views
Published on October 6, 2012
Description
Just in time for Halloween, this is a pumpkin. It has a flat bottom to help it sit on a table or where ever you decide it should sit.
Instructions
Printed at 1/2 scale on a uPrint with a layer thickness of 0.010 inches and a low density infill. The print took about 20 minutes or so. I think it came out pretty well. It could probably use a dip into some acetone to even out the layers.
*this is an iPhone photo, maybe I can get a better one up later. :)
*this is an iPhone photo, maybe I can get a better one up later. :)
License
More from KellyBC
More from Food & Drink
You must be logged in to post a comment.