Maze Bolt V2
Description
Just a maze on a bolt really. Made for a school project in Inventor :)
Instructions
Print both the bolt and nut.
Printed without support on a MakerBot.
Does require a bit of clean up afterwards for the ring to move freely.
Printed without support on a MakerBot.
Does require a bit of clean up afterwards for the ring to move freely.
You must be logged in to post a comment.
License
Maze Bolt V2 by snoballz is licensed under the Attribution - Share Alike - Creative Commons license.
This thing CANNOT be printed without support. There are too many overhangs.
Don't even waste your filament without first turning on support material.
ah yes it can, i printed it without support... you do get a bit of stringy plastic underneath but you just cut it off with a stanley knife.