Toy Boat
13
Likes
569
Downloads
2567
Views
Published on October 8, 2012
Description
This is a simple toy boat with some detail, but not very much. I am printing one for my 7 month old son, well actually it is for his room. Made in SolidWorks.
Instructions
If you print this one without scaling, it would be about 10 inches long so you may want to scale it down before printing. I will upload a picture of the printed model when I have it done.
I made a 1/4 scale print on a uPrint. I left the bottom of the boat in the xy plane and printed with a layer thickness of 0.010 inches, with a low density infill. I have some banding on the deck of the boat, but the model printed in about 25 minutes with no problems.
*This is an iPhone picture, maybe I can get a better picture up later. :)
I made a 1/4 scale print on a uPrint. I left the bottom of the boat in the xy plane and printed with a layer thickness of 0.010 inches, with a low density infill. I have some banding on the deck of the boat, but the model printed in about 25 minutes with no problems.
*This is an iPhone picture, maybe I can get a better picture up later. :)
You must be logged in to post a comment.
License
.5X scale, and the print looks very nice at .2mm layer height.