Orca V4x 'Hobbed Shaft' upgrade parts
1
Likes
117
Downloads
497
Views
Published on November 9, 2012
Description
If you want to upgrade the Orca v4x extruders, for using Camiel's Hobbed Shaft, you need to print 2 pieces of the carriage holder.
These are them
These are them
Instructions
Just print using the old extruder,
reassamble with the new shaft,
re-calibrate the feed value
On you go again :-)
Thomas
3daybreaker.blogspot.com
reassamble with the new shaft,
re-calibrate the feed value
On you go again :-)
Thomas
3daybreaker.blogspot.com
License
Orca V4x 'Hobbed Shaft' upgrade parts by 3daybreaker is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3daybreaker
More from 3D Printer Extruders
You must be logged in to post a comment.