Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
APM2 and Receiver Mount
9
Likes
79
Downloads
1159
Views
Published on October 10, 2012
Description
This thing was made with Tinkercad. Edit it online tinkercad.com/things/cQerwDH6wm1
This is an adaptor plate for an Ardupilot to mount to the squared 45 mm mounting points on my tricopter frame. I am looking to add a case cover for the board, but need to design something to allow the on board GPS antenna to get signal.
This is an adaptor plate for an Ardupilot to mount to the squared 45 mm mounting points on my tricopter frame. I am looking to add a case cover for the board, but need to design something to allow the on board GPS antenna to get signal.
Instructions
Modify and Print. I made this to adapt the mounting holes on my APM2 to my Tricopter top plate mounting holes. I have added zip tie holes on the sides to eventually attach a case cover. I have also added zip tie holes to zip tie my receiver to the underside of the plate.
You must be logged in to post a comment.
License
APM2 and Receiver Mount by MobileOverlord is licensed under the Attribution - Share Alike - Creative Commons license.
More from MobileOverlord
More from R/C Vehicles
Over on diy drones we just started a 3D printed drone part group, hope to see you/this there.