MH kitchen support for lighter and corkscrew
1
Likes
103
Downloads
500
Views
Published on October 13, 2012
Description
In my recently purchased motor home, we use a gas lighter and a cork screw. It seemed nice to make a special support for them, hanging from the standard glass hazard screen besides the stove.
Thomas
3daybreaker.blogspot.com
Thomas
3daybreaker.blogspot.com
Instructions
Print and clip to any 4mm vertical panel.
I print with 1.75 filament, have sliced with Slic3r 0.3 layer hight,
infill 0.15 with honeycomb, 3 skirts.
Thomas
3daybreaker.blogspot.com
I print with 1.75 filament, have sliced with Slic3r 0.3 layer hight,
infill 0.15 with honeycomb, 3 skirts.
Thomas
3daybreaker.blogspot.com
License
MH kitchen support for lighter and corkscrew by 3daybreaker is licensed under the Attribution - Share Alike - Creative Commons license.
More from 3daybreaker
More from Kitchen & Dining
You must be logged in to post a comment.