Fallout Stealth Boy Replica

by Hyena_Of_Doom, published

Fallout Stealth Boy Replica by Hyena_Of_Doom Oct 13, 2012

Thing Info

9070Views 2264Downloads Found in Props
Report Thing


This is a replica of the Stealth boy from fallout 3/ Fallout new Vegas. I was originally planning to print from the in game model but the resolution of the model was way too low so this was made from the ground up with reference to the in game files. I’ve tried to get the scale accurate to 1:1 by eye but obviously there are no exact measurements available.


The case halves and the antenna require support for printing but everything else prints fine without it. the case halves can be glued or four m3x10 machine screws can be used.

More from Props

view more

Thing Info

9070Views 2264Downloads Found in Props
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App

I have a replicator 2 and no matter how I try to print the top, bottom, and front buttons, it always fails. Any suggestions?

only issues I had were the front switches don't all sit flat, so you need support.

Flipping the antenna should allow it to be printed without support!