Bow Tie
56
Likes
334
Downloads
6708
Views
Published on October 13, 2012
This thing was Featured on October 13, 2012
Description
Wear your geek cred around your neck!
Instructions
I recommend printing the bow tie out without the solid top and bottom layers (change this setting in your slicing software). This allows the infill to be visible and creates holes to pass string or wire to tie it around your neck!
You must be logged in to post a comment.
oriface
on
October 16, 2012
said:
Can I have some tips on what Skeinforge35 running a TOMmk6 settings I should use? I unticked "activate bottom" button but i still seem to have a Bottom...Bum
cerberus333
on
October 14, 2012
said:
this must be accompanied with a fez!
and I totally was thinking Dr Who, Not Bill Nye.
Roach
on
October 14, 2012
said:
For some reason I read this as "Bill Nye"
I think it was because of the picture.
License
Bow Tie by ElectricSlim is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from ElectricSlim
More from Accessories
amazing!