Jack Skull Lantern
15
Likes
170
Downloads
984
Views
Published on October 13, 2012
Description
Jack Skull Lantern
Instructions
Printed using 2 shells and 0% infill
i used replicator accelerated settings
80mm/sec .27 slice
weighed 27.7 grams at the size i posted.
it gets quite a few gaps on top at those settings
i do post fill-in with ABS/acetone 'goop'(thick as white glue)
i will be putting a light inside so the no infill is my preference.
(not to mention the low plastic use and quicker print time)
you can probably eliminate the gaps by either
using infill, or more shells
i used replicator accelerated settings
80mm/sec .27 slice
weighed 27.7 grams at the size i posted.
it gets quite a few gaps on top at those settings
i do post fill-in with ABS/acetone 'goop'(thick as white glue)
i will be putting a light inside so the no infill is my preference.
(not to mention the low plastic use and quicker print time)
you can probably eliminate the gaps by either
using infill, or more shells
License
Jack Skull Lantern by cerberus333 is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from cerberus333
More from Creatures
Thanks.
I think there is a big niche of this hobby
for folks to paint models.
years ago i recall ceramics being made and hobbiests would
paint them (glazing) and have them fired.
I use acrylic craft paints which i followed up with a spray on
clear enamel.