RepRapPro Huxley Washer
2
Likes
90
Downloads
555
Views
Published on October 14, 2012
Description
A small washer to take the strain on the Z-motor brackets. Can be fitted post construction.
Instructions
Loosen the outer nut on the z-motor bracket. Pop the washer in the gap, around the M6 bar, closed end outwards. Tighten everything up, job done!
License
RepRapPro Huxley Washer by drdpj is licensed under the Attribution - Share Alike - Creative Commons license.
More from drdpj
More from 3D Printer Parts
You must be logged in to post a comment.