Drive Chain
74
Likes
880
Downloads
5209
Views
Published on October 15, 2012
Description
This is to make a #41 drive chain (almost). The width is for 1/8" sprokets, but it's otherwise #41 spec. I made this to use for the Lyman Filament Extruder. The stress on the chain is too much for it. This chain can take a fair bit of pull, but the extruder was just too much. Maybe someone has a use for this.
Instructions
Print 100% fill and assemble.
You must be logged in to post a comment.
aubenc
on
October 15, 2012
said:
I love it! And I'll have to give it a try one of these days!!
(it remembers me my 1st thing in Thingiverse, printers have changed so much since then... )
MichaelAtOz
on
October 15, 2012
said:
Nice!! <- two thumbs up
Yep something like this is in my design imaginings.
Thanks for sharing :)
License
Drive Chain by bottleworks is licensed under the Attribution - Share Alike - Creative Commons license.
More from bottleworks
More from Parts
Hmmm, I wonder if it would be strong enough to replace the belts on a printer?
No. At least, not a good printer. You would be introducing a huge amount of backlash.