T-Rex Necklace Pendant
by ZippyMultirotors, published
I printed this at .1 mm layer height to get the most detail. It took about two hours to print without support or raft.
I also did this at 80mm/sec print speed and 100mm/sec traverse speed. I would suggest slowing this down a bit more to capture all the detail.
I suggest that you also superglue the bottom half to the upper so it doesn't just pop right out.
Liked ByView All
Give a Shout Out
T-Rex Necklace Pendant by ZippyMultirotors is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving ZippyMultirotors a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure ZippyMultirotors would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).