Barbell-style PSU Prusa Mount

by Georgewchilds, published

Barbell-style PSU Prusa Mount by Georgewchilds Oct 16, 2012

Thing Info

6784Views 648Downloads Found in 3D Printer Accessories
Report Thing


I really liked the original PSU Mount that I derived this from, but the upgraded design seemed a bit like a Volvo to me.

So I sucked it into Openscad and matched up the screw holes, adding in the barbell design I found on a different mount.

This PSU mount is stable and strong, but make sure the infill is relatively high for the thinner X configuration.

Here's a video of the build:



If you intend to mount your PSU on the typical left rear side (or the right front side) of your Prusa Mendel printer, download the STL file and print it out. Be careful not to home the x-axis at the end of the print because it's relatively tall.

If you want to mount the PSU on the right rear side (or the left front side - unusual, but with reprap you never know), then uncomment the mirror(1,0,0) command near the start of the .scad file.

I found two #8 screws, about 1/2" long, that fit into the holes in the PSU.

More from 3D Printer Accessories

view more

Thing Info

6784Views 648Downloads Found in 3D Printer Accessories
Report Thing

Liked By

View All

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

All Apps

This extension connects Thingiverse with Makeprintable, a cloud-based mesh repair service that analyzes, validates and repairs most common mesh errors that can occur when preparing a 3D design file...

App Info Launch App