Finger Snowboard
23
Likes
150
Downloads
1821
Views
Published on October 17, 2012
Description
Winter is approaching and here's what you (and your kids) need to practice for the snow! Just print this board in single or multi color and lay down some nice curves.
Instructions
My son and a friend asked me to make some Finger-snowboards. Kids love them and it's my fav 3DP giveaway these days! I usually print them in PLA and then put the tip's in boiling water to bend them up a little. Stickers are great for personalizing the boards.
To make two-color versions, I use 3mm plastic that is about 50cm long and then change to a different color boots. How much you'll need to use on your printer will vary, but experimenting is fun!
The boards in the images were printed with PLA from Faberdashery.
To make two-color versions, I use 3mm plastic that is about 50cm long and then change to a different color boots. How much you'll need to use on your printer will vary, but experimenting is fun!
The boards in the images were printed with PLA from Faberdashery.
License
Finger Snowboard by jensa is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from jensa
More from Toys & Games
You must be logged in to post a comment.