Replicator print head centering calibration thing
7
Likes
100
Downloads
746
Views
Published on October 17, 2012
Description
I couldn't seem to properly center my replicator print head, so here is a simple rectangle that outlines the entire build platform with a thin rectangle.
Instructions
10 Ensure your Replicator is plugged into your computer via USB
20 Generate GCOODE
30 Print
40 Watch the print head. Use calipers to visually measure how much the print head goes past the the edge build platform.
50 Go into Machine | Onboard Preferences | Homing / VREFs to adjust the offsets. Press "Commit changes" to upload them to the firmware.
60 Goto 20
20 Generate GCOODE
30 Print
40 Watch the print head. Use calipers to visually measure how much the print head goes past the the edge build platform.
50 Go into Machine | Onboard Preferences | Homing / VREFs to adjust the offsets. Press "Commit changes" to upload them to the firmware.
60 Goto 20
You must be logged in to post a comment.
Collections
Replicator
by AK_Eric
Replicator Upgrades - Replicator Calibration Prints
by garyacrowellsr
Replicator Essentials
by SparkySD
License
Replicator print head centering calibration thing by LeeroyLee is licensed under the Attribution - Creative Commons license.
More from LeeroyLee
More from 3D Printing Tests
BTW, it's a 220mm by 140mm rectangle, which leaves a little room to spare. The official specs say that the build platform is 225 by 145, although ReplicatorG thinks that is too much.