Ultimaker Duct Spacer
2
Likes
99
Downloads
925
Views
Published on October 18, 2012
Description
A spacer piece that allows fan ducts designed to be mounted to the bottom of the aluminum plate on an Ultimaker with a v1 extruder to be used with a v2 extruder. Should work well with most ducts, but was designed for the one pictured.
Has added advantage in that it seems to better isolate the duct from any heat related deformation over time.
I should have printed it in a different color than the duct; it is the extra yellow plate bit at the top.
Has added advantage in that it seems to better isolate the duct from any heat related deformation over time.
I should have printed it in a different color than the duct; it is the extra yellow plate bit at the top.
Instructions
0. Rotate the part so it is actually FLAT on the print bed.
1. Print (~60% infill, ~0.8mm walls, etc..)
2. Stick between existing duct & aluminum plate.
1. Print (~60% infill, ~0.8mm walls, etc..)
2. Stick between existing duct & aluminum plate.
You must be logged in to post a comment.
License
More from bbum
More from 3D Printer Parts
some fans still have problems because the nozzle on the V2 hotend is shorter than the V1 by 3 or 4 mm