M4 T-slot nut for Mendelmax
27
Likes
401
Downloads
2488
Views
Published on October 18, 2012
Derived from
M5 T-slot nut substitute
by blacki
Description
The design is the same as the original by blacky, i just redesigned in sketchup reducing the nut and washer hole and simplify the mesh for a better print.
My nut measures 8mm external diameter, and 3mm height. The washer is 9mm diameter and 1mm height.
I printed mine with PLA, .35 nozzle, .25 layer height and works good but if you want more strength reduce the layer h to .20. I sliced it with Slic3r
My nut measures 8mm external diameter, and 3mm height. The washer is 9mm diameter and 1mm height.
I printed mine with PLA, .35 nozzle, .25 layer height and works good but if you want more strength reduce the layer h to .20. I sliced it with Slic3r
Instructions
Just print, put the nut and the washer! :)
You must be logged in to post a comment.
License
M4 T-slot nut for Mendelmax by Vise is licensed under the Attribution - Share Alike - Creative Commons license.
More from Vise
More from 3D Printer Parts
I couldn't get them to fit in my Misumi extrusions (Ord Bot Hadron) so I trimmed about 0.25 mm from each side. Thanks!