Part to attach the safety cutoff in your 3D Printer
1
Likes
204
Downloads
567
Views
Published on October 18, 2012
Description
This is a part to attach your safety cutoff in your 3D Printer next to the rainbow bridge in the Z axis.
I will add pictures later in order to show you where you have to place it.
You can print the part in two different parts without support or in one part adding supports in skeinforge with Raft enabled but with Cross Hatch disabled ( too hard to remove the supports with Cross Hatch)
I will add pictures later in order to show you where you have to place it.
You can print the part in two different parts without support or in one part adding supports in skeinforge with Raft enabled but with Cross Hatch disabled ( too hard to remove the supports with Cross Hatch)
Instructions
If you print the part in two different parts then you have to glue it together with a mix of acetone and abs.
To see how the support is attached on the machine and how the safety cutoff is attached on the support click on the two pictures where there are no pictures and then click on original image and you will see them.
To see how the support is attached on the machine and how the safety cutoff is attached on the support click on the two pictures where there are no pictures and then click on original image and you will see them.
License
Part to attach the safety cutoff in your 3D Printer by Anais25 is licensed under the Attribution - Share Alike - Creative Commons license.
More from Anais25
More from 3D Printer Parts
Sorry for answering so late, I added pictures in order to show where exactly the support to attach the safety cutoff is on the machine.