Loading

FIVE Column Wire Flat Bottom

by PropellerScience, published

FIVE Column Wire Flat Bottom by PropellerScience Oct 19, 2012

Description

I hope I'm not stretching the definition of Derivative too much with this, but it is different.
I had a hard time getting it to stick to the build platform so I cut the bottom flat in Netfabb to get rid of the fillet.

Recent Comments

view all

Great!

More from Math Art

view more

Liked By

view all

Tags

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Printed with SAILFISH accelerated firmware! (thing:32084)
Print as seen in the picture. I printed mine with PLA with .20mm layer height, and one extra shell, although I would try 2 extra shells if I printed another one. Print-o-Matic was on, and temps were 60C build platform and 200C extruder. I used a glass plate on top of the build platform with AquaNet super duper hairspray on the glass (see thing:28787) to keep it stuck, it seems to work quite well, and it makes my workshop smell pretty :-)
Weird thing: During the print there were two extra layers that got printed that I can't see in RepG. Check out the picture. They didn't work well, but should clean out fine as will a couple sags under the tops of some holes.
No supports were used.

Comments

You must be logged in to post a comment.

rvdovic on Oct 29, 2012 said:

Great!

Top