Openbeam - Extension Joint
12
Likes
84
Downloads
952
Views
Published on October 19, 2012
Description
OPENBEAM is an amazing new aluminum extrusion design that gets rid of the expensive T-nuts used on other extrusions types.
It replaces the expensive T-Nuts with M3 sized nuts and bolts that are available form most hardware stores at an fraction of the T-Nut's cost.
This joint is good for extending small off cuts of Openbeam. It has 4 screw holes per side and has internal grooves that slot on all 4 sides of the Openbean extrusion.
This joint can also be modified into a 3 or 4 joint component.
Protoneer Blog - blog.protoneer.co.nz
Protoneer Shop - shop.protoneer.co.nz
It replaces the expensive T-Nuts with M3 sized nuts and bolts that are available form most hardware stores at an fraction of the T-Nut's cost.
This joint is good for extending small off cuts of Openbeam. It has 4 screw holes per side and has internal grooves that slot on all 4 sides of the Openbean extrusion.
This joint can also be modified into a 3 or 4 joint component.
Protoneer Blog - blog.protoneer.co.nz
Protoneer Shop - shop.protoneer.co.nz
Instructions
No instructions provided.
License
Openbeam - Extension Joint by protoneerconz is licensed under the Attribution - Share Alike - Creative Commons license.
More from protoneerconz
More from DIY
You must be logged in to post a comment.