X-ends for holding 20x20 extrusion 3 hole delrin nuts/bushings
4
Likes
105
Downloads
649
Views
Published on October 20, 2012
Description
These x-ends use SA bushings (same OD for 8 or 10mm rods)
These x-ends are compatible with 3 hole delrin nuts
These x-ends don't hold x-rods, they hold a single 20x20 extrusion.
Both ends have an integrated bolt holder meant to interface with a z-endstop held in the lower part from thingiverse.com/thing:28425
By the way these are intended for 605zz idler bearings, you'll have to enlarge the hole either before or after printing if you intend to use 608zzs.
These x-ends are compatible with 3 hole delrin nuts
These x-ends don't hold x-rods, they hold a single 20x20 extrusion.
Both ends have an integrated bolt holder meant to interface with a z-endstop held in the lower part from thingiverse.com/thing:28425
By the way these are intended for 605zz idler bearings, you'll have to enlarge the hole either before or after printing if you intend to use 608zzs.
Instructions
No instructions provided.
License
X-ends for holding 20x20 extrusion 3 hole delrin nuts/bushings by Simonious is licensed under the Attribution - Creative Commons license.
More from Simonious
More from 3D Printer Parts
You must be logged in to post a comment.