Doggie new joints
Description
This is a derivative of Doggie by TrevM. I like this model a lot but had trouble with fitting the legs. I modified the OpenSCAD to get joints that can easily snap onto the joint balls. Also, I modified the plate to be able to print 2 Doggies at once with dual extrusion.
Enjoy!
Enjoy!
Instructions
Tested at scale = 1
Please see original for more instructions: thingiverse.com/thing:29475
The legs should snap in place easily. The head is a bit harder but usually fits with a firm push.
I removed the support for the leg ball joints: At scale 1 they were not required. However, if you try with larger scales you may have to put them back.
Please see original for more instructions: thingiverse.com/thing:29475
The legs should snap in place easily. The head is a bit harder but usually fits with a firm push.
I removed the support for the leg ball joints: At scale 1 they were not required. However, if you try with larger scales you may have to put them back.
License
Doggie new joints by sylefeb is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.