Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Star Trek Harry Mudd Flower
8
Likes
296
Downloads
815
Views
Published on October 20, 2012
Description
My friend went to Shore Leave as Harry Mudd and I made this for his costume.
It's not perfect but it gets the job done.
It's not perfect but it gets the job done.
Instructions
I don't remember my settings, but this will print without supports, it maybe a little sloppy. I beefed up the petals with some hot glue on the back.
The complete version prints with the center and petal 'buttons'.
The 'petals' and 'buttons' files make it easier to print in different colors or to paint the pieces to match the original prop.
Print pieces, paint if desired, glue together, glue a saftey pin on back using pin holder.
This is a cleaned up version of my original and I haven't actually printed this yet, so if anyone has a problem, let me know.
The complete version prints with the center and petal 'buttons'.
The 'petals' and 'buttons' files make it easier to print in different colors or to paint the pieces to match the original prop.
Print pieces, paint if desired, glue together, glue a saftey pin on back using pin holder.
This is a cleaned up version of my original and I haven't actually printed this yet, so if anyone has a problem, let me know.
License
Star Trek Harry Mudd Flower by countspatula is licensed under the Attribution - Share Alike - Creative Commons license.
More from countspatula
More from Props
You must be logged in to post a comment.