Feet w/ shield holder
3
Likes
88
Downloads
857
Views
Published on October 20, 2012
Derived from
Replicator Foot with Grip Pad
by garyacrowellsr
Description
I liked the idea of feet with a gripper pad but I also wanted a place to store my front shield. So I moved them out and added some 1/4" slots on the left feet. I also added tapped holes so they won't fall off when I lift the bot.
Instructions
Print and tap the holes 1/4-20 or 6mm. Fasten to bot with set screws. I used 1-1/2" non slip pads from Home Depot.
License
Feet w/ shield holder by kcmelty is licensed under the Attribution - Share Alike - Creative Commons license.
More from kcmelty
More from 3D Printer Accessories
You must be logged in to post a comment.