Ikea Komplement Large Box Wheel Mk 2
0
Likes
165
Downloads
638
Views
Published on October 22, 2012
Description
A wheel for Ikea's 'Kompliment' large plastic store box.
It clips into the existing slots on the box.
It clips into the existing slots on the box.
Instructions
Print 4 off, detatch wheel and discard its support ring. Slide wheel into lower bearing hole, click into top.
I used ABS at 20% infill, 0.2mm sliced in Cura (Skeinforge) using dwindle and retraction on Ultimaker. No support needed.
The wheel/shaft is printed offset to minimise string bridging - it can be printed in its bearing holes, but takes a bit of fiddling to get spinning due to print artifacts.
I used ABS at 20% infill, 0.2mm sliced in Cura (Skeinforge) using dwindle and retraction on Ultimaker. No support needed.
The wheel/shaft is printed offset to minimise string bridging - it can be printed in its bearing holes, but takes a bit of fiddling to get spinning due to print artifacts.
License
Ikea Komplement Large Box Wheel Mk 2 by Lampbus is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from Lampbus
More from Organization
You must be logged in to post a comment.