Venturi effect cnc mist nozzle
19
Likes
93
Downloads
1308
Views
Published on October 23, 2012
Description
This was designed to go on the end of segmented hose to spray a mix of air and liquid lubrication for use in a cnc machine.
A tube connects the nozzle to a container with the lubricant. The flow of air (tested at 3bar) draws in the fluid trough the tube and mixes it with air. The tube entrance is tapered to accept tubes from 3 to 6mm. (1/8 to 1/4 inch)
More information at: robosavvy.com/forum/viewtopic.php?p=35892#35892
A tube connects the nozzle to a container with the lubricant. The flow of air (tested at 3bar) draws in the fluid trough the tube and mixes it with air. The tube entrance is tapered to accept tubes from 3 to 6mm. (1/8 to 1/4 inch)
More information at: robosavvy.com/forum/viewtopic.php?p=35892#35892
Instructions
This was designed for segmented hose with a sphere diameter of 12.5mm. I assume that is standard.
However depending on how much your printer squishes the first layers you might have to trim a bit around the lower edges so that you can insert the nozzle in the segmented hose.
However depending on how much your printer squishes the first layers you might have to trim a bit around the lower edges so that you can insert the nozzle in the segmented hose.
License
Venturi effect cnc mist nozzle by robosavvy is licensed under the Attribution - Creative Commons license.
You must be logged in to post a comment.