Earphone Cable Organizer
by robots-dreams, published
After a few weeks using the Wishbone based earphone cable organizer ( http://www.thingiverse.com/thing:31053 ) I decided to tackle a redesign to eliminate some of the problems.
With the original design the cables would sometimes pop out of the end clips, and on one occasion the cables slipped out of the center piece allowing the organizer to fall on the floor.
This redesign staggered the center slot so that it retains the cables during use. The end clips were also redesigned.
[10/24/2012] Added a shorter/low-profile version.
Printed with PLA at 100 micron layers.