Cell Phone Stand
by PerryT, published
The original fit a phone up to 1/2" thick. On a request i have added two more lower sections to accommodate larger phones. .125" & .25" larger. I uploaded medium and VERY high resolution parts so take your pic, look at the file sizes and download what you would like. I am going to also upload the top section on VERY high res also for those of you who like real smooth prints as i do. Hope everyone enjoys. Let me know of any other good ideas for improvements! :)
Recent Commentsview all
You are welcome...
And that is a great idea.... a design for business cards.... and thanks for the comment about the original size... i will add your comments to the part notes....
Thanks again Mystic.....
Your revised measurements should work for just about any phone case now. Just so everyone knows, the original cradle section where the phone sits was 1/2". I will have to print a new one for my phone with the wider cradle. The first one is now a business card holder!!! Thanks again for the great design.
Liked Byview all
Give a Shout Out
just print the top and bottom separate to reduce warping.
You must be logged in to post a comment.