Replicator hood latch
3
Likes
145
Downloads
563
Views
Published on October 24, 2012
Description
This little latch helps keep the front panel of your Replicator hood securely latched. Much quieter and reduces drafts.
Instructions
Print it. Position it against the front of the Replicator with the front panel of the hood in place, and mark where it should go. Drill a 3mm (or 1/8 inch) hole. Put a 16mm M3 screw through the latch, and hold it in place with an M3 nut.
Feel free to edit the OpenSCAD file if you have used thicker plastic - current STL is for 1/8" plastic.
Feel free to edit the OpenSCAD file if you have used thicker plastic - current STL is for 1/8" plastic.
License
Replicator hood latch by gpvillamil is licensed under the Creative Commons - Public Domain Dedication license.
More from gpvillamil
More from 3D Printer Accessories
You must be logged in to post a comment.